Swipe to the right
Installing a British Customs Underplate
|Parts Needed:||Fits The Following Motoecycles:||Tools Required:||Weekend Project Category:||Difficulty:||Time it Takes to install:|
Related Weekend Project Upgrades
Step 1:Remove the stock seat screws.
- Remove the seat.
Step 3:Unplug the rear tail light harness.
- Unscrew the T-30 Torx screws holding the rear fender.
Step 5:Remove the rear fender.
- Locate the underplate, hold it into place on the bike.
Step 7:Slide the two shorter screws with the smaller flat washers through the mounting holes. Then thread the larger flat washer and locknut onto the underside of the plate.
- Slide the two larger screws with the smaller flat washers through the mounting holes. Then thread the larger flat washer and locknut onto the underside of the plate.
Step 9:Using a 4mm Allen and a 10mm socket, tighten the mounting hardware of the fender eliminator plate.
Installation Complete!Congratulations! You have successfully completed the installation of your new British Customs Underplate!