BC902-(055/057)-BR | Installation Instructions for Triumph Street Twin Performance Tips

posted this on Jul 1, 2016

Upgrading your exhaust makes one of the most distinctive differences possible on the Triumph Street Twin. The Performance Tips help you shed a few unnecessary pounds to gain some horsepower, and enrich the engine's throaty sound. This upgrade only takes around 25 minutes total, is fairly simple, and doesn't require other performance upgrades in order to properly run. If you've been thinking about it, upgrading your footpegs while you're in there will save you a lot of time, and will help further transform your bike.

Fitment:

  • Triumph Street Twin

Tools required:

  • 10mm Allen wrench
  • 12mm wrench

Total time the job takes:

  • 25 minutes

Difficulty:

  • Rookie

Step 1:

Remove stock exhaust mufflers and heat shields. If you aren’t sure how to do this, please refer to our guide covering how to remove your stock exhaust on our site’s Resource Center.

Step 2:

To install right Performance Tip, use a 12mm socket wrench to remove bolt along bottom of right foot peg mount.

Step 3:

Place stock gaskets on catalytic converter’s right exit pipe. Place clamp over gaskets and use a 10mm socket wrench to loosely tighten the clamp.

Step 4:

Place end of right Performance Tip into catalytic converter.

Step 5:

Use a 12mm socket wrench to tighten right Performance Tip rear bracket to lower foot peg mount. Be sure to use washer.

Step 6:

Tighten clamp securing right Performance Tip to catalytic converter.

Step 7:

Reinstall right heat shield.

Step 8:

To install left Performance Tip, place stock gaskets on catalytic converter’s left exit pipe. Place clamp over gaskets and use a 10mm socket wrench to loosely tighten the clamp.

Step 9:

Place end of left Performance Tip into catalytic converter.

Step 10:

Use a 12mm socket wrench to tighten left Performance Tip rear bracket to lower foot peg mount. Be sure to use washer.

Step 11:

Tighten clamp securing left Performance Tip to catalytic converter.

Step 12:

Reinstall left heat shield.