HOW TO INSTALL BC PLUG N PLAY RETRO REAR TURN SIGNALS ON TRIUMPH STREET SCRAMBLER

Jason Panther posted this on Apr 14, 2017

HOW TO REMOVE THE REAR FACTORY TURN SIGNAL (LEFT) FROM YOUR TRIUMPH STREET SCRAMBLER

Step 1

Using a T20 Torx remove the (3) screws that secure the electrical cover from the underside of the fender.

Step 2

Remove left-hand turn signal using a 10mm wrench and a 5mm allen.  

Step 3

Disconnect wiring (+) Green/Red > White Wire (-) Black > Black (MC Harness > Turn Signal)

HOW TO INSTALL BC PLUG N PLAY RETRO REAR TURN SIGNAL (LEFT) ON YOUR TRIUMPH STREET SCRAMBLER

STEP 4

Identify left-hand marker light.   When mounted to the bike the phillips head needs to be facing down.  Loosen the phillips screw to expose the allen bolt.  

 

STEP 5

Remove nut from BC Plug and Play Marker Light. Run Connectors through the rear hole on factory mounting location.

 

STEP 6

Tighten Turn signal using a 4mm allen and 10mm wrench

 

STEP 7

Adjust turn signal to the desired angle and tighten screw to secure turn signal in position using phillips screwdriver

 

STEP 8

Connect turn signals (+) green/red > black/red (-) black > black (MC Harness > Turn Singal)

HOW TO REMOVE THE REAR FACTORY TURN SIGNAL (RIGHT) FROM YOUR TRIUMPH STREET SCRAMBLER

 

STEP 9

Remove right-hand turn signal using a 10mm wrench to secure the nut and a 5mm allen to remove the screw

 

STEP 10

Disconnect Wiring (+) Geen/White > White Wire (-) Black > Black (MC Harness > Turn Singal)

HOW TO INSTALL BC PLUG N PLAY RETRO REAR TURN SIGNAL (RIGHT) ON YOUR TRIUMPH STREET SCRAMBLER

 

STEP 11

Identify Right-hand marker light by holding marker light up to bike (phillips head screw always faces down when mounted. Loosen phillips head screw to expose allen bolt

 

STEP 12

Remove nut from BC Plug and Play Marker Light. Run Connectors through the rear hole on factory mounting location.

 

STEP 13

Tighten Turn signal using a 4mm allen and 10mm wrench

 

STEP 14

Adjust turn signal to the desired angle and tighten phillips screw to secure turn signal in position

 

STEP 15

Connect turn signals (+) green/white > black/red (-) black > black (MC Harness > Turn Singal)

 

STEP 16

Reinstall electrical cover that was removed in Step 1. Note: Install two top screws 1st (silver screws)