O2 Sensor Eliminator Plug - Sold Individually

O2 Sensor Eliminator Plug - Sold Individually
O2 sensor plug block-offs for use with Dyno Jet Power Commander. Sold Individually, you will need to buy quantity two for a pair of pipes.
Usually ships in 3-5 Business Days

This product is not for sale in California and use is restricted for closed course competition only. Not intended for street use on any pollution controlled motor vehicle. Any order constitutes Buyers offer to Seller and agrees to the Terms and Conditions stated here upon purchase or acceptance.



The O2 eliminator is a connector with a simple circuit that provides a signal to the ECU preventing any error signals to be sent to the control unit. Newer Triumph models are equipped with oxygen sensors that communicate the amount of oxygen present in the exhaust gas to the ECU. The ECU is programmed to comply with certain air / fuel ratios and may cause the motorcycle to run too lean. With the O2 Sensor Eliminator installed, you are able to control the air/fuel ratio.

Sold individually.


  • Bonneville/T100/Mag Wheel EFI- 2 required
  • Thruxton EFI- 2 required
  • Scrambler EFI- 2 required

This part fits the following models
Triumph Bonneville T100 EFI - 2009-2016
Triumph Bonneville Mag - 2009-2015
Triumph Scrambler 900 EFI - 2009-2016
Triumph Thruxton 900 EFI - 2009-2016
*Refer to Description in event of VIN specific fitment
Q & a

Product Questions

  • Submit your question to our community.

After installing these would I still have to get my T100 Bonneville remapped?
You will not need to remap after installing the O2 sensor eliminator plugs.
Customer Support answered on January 24, 2017