Relocating the handlebar-mounted turn signals has been a difficult task for America and Speedmaster owners. Most aftermarket turn signals have nowhere to go on the Triumph cruiser. British Customs has a solution, an alternative turn signal mount that creates mounting points on the stock fork tubes. The Turn Signal Relocation Brackets make it easier to personalize the look of the front end, mounting the signals of your choice on the fork, for a sleeker, lowprofile look. They virtually disappear against the fork tubes. Made from strong, weather-resistant stainless steel, they will work with lamps with up to an 8 mm mounting shank, so you can choose from hundreds of aftermarket or custom signals. Each bracket is drilled with a wiring hole, protected with a rubber grommet. They are polished to a mirror finish and install in minutes with simple tools. Installation note: Will not fit bikes with Triumph accessory case guard/crash bar or stock turn signals.
- Creates front turn mounting points on the fork tubes
- Fit any aftermarket or custom lamps, up to 8mm shaft
- Wiring routing hole and rubber grommet Installs in minutes
- Made in USA
Fits- America up to VIN 468389 and Speedmaster up to VIN 469049 *VIN refers to the last 6 digits
This part fits the following models Triumph America Carb - 2002-2008 Triumph Speedmaster Carb - 2003-2008*Refer to Description in event of VIN specific fitment
Write Your Own Review
- Q & a
will this fit my 2014 America?A:These brackets are designed to work with carb models and early EFI depending on the VIN. Currently we do not have a turn signal relocation bracket for late EFI models.
Fits- America up to VIN 468389 and Speedmaster up to VIN 469049 *VIN refers to the last 6 digitsCustomer Support answered on November 22, 2016