- Triumph Street Twin
- T25 wrench
- T40 wrench
- 4mm Allen wrench
Total time the job takes:
- 1 hour
The easiest way to install the BC Four Bolt Risers is to install them on the triple clamp once it’s been removed. If you’re unsure how to do this, refer to the guide on our site’s Resource Center.
NOTE: The installation process is the same whether the triple clamp is on or off the forks.
Insert supplied bolt into bottom piece of Four Bolt Riser.
OPTIONAL: Put spacer on bolt if desired. Make sure that the spacer locks into the bottom of the riser.
Put riser bolt into the hole in the triple clamp. Place washer over bolt.
Secure Four Bolt Riser with lock nut using a 17mm wrench. Repeat steps 2-4 on the other side to complete installation.
Your have successfully installed your four bolt risers! If you have any questions about how to install your triple clamp, handlebars, or any other related controls parts, refer to the guides on our site's Resource Center.