- Triumph Street Twin
- Flat head screwdriver
- 6mm wrench
- Hook (optional, but recommended)
Total time the job takes:
- 30 minutes
Use a flat head screwdriver to remove retaining ring from bottom of foot peg pin.
Remove pin, and support foot peg as you remove the foot peg. Be wary that the foot peg is spring loaded, and that the spring will launch out if you are not careful when removing it.
Remove stock foot peg.
Put BC clevis in place, and secure with pin.
Put a dot of blue Loctite on the end of each supplied pin, and insert them into the four (4) mounting holes in the clevis.
Slide foot peg onto pins at desired angle.
Apply blue Loctite to screw and secure foot peg to clevis with 6mm Allen wrench.
Pull pin back out of clevis.
Place spring in foot peg assembly. Note correct spring positioning.
Put foot peg in place.
Insert pin down through spring. Make sure the groove for the retaining ring is on the bottom side of the pin.
Secure pin in place with the stock retaining ring using a flat blade screwdriver.
Repeat steps 1-12 on the left side to install left driver foot peg and clevis.
Note: To remove the pin from the left driver foot peg, you must loosen the two bolts securing the bracket to the frame with a 6mm Allen wrench. Once the bolts have been loosened, you can angle the foot peg bracket to pull out the pin.