- Triumph Bonneville
- Triumph Thruxton
- Triumph Scrambler
- 12mm wrench
- 5mm Allen wrench
Total time the job takes:
- 10 minutes
Using a 12mm wrench, remove the stock passenger peg. While loosening nut, push foot peg towards mount to prevent it from turning.
Install the Passenger Peg Block-Off using the stock washer and rubber bushing, and the supplied bolt. It’s best to start tightening by hand and finish using a 5mm Allen wrench.
Repeat on the opposite side. Clean any hand prints from exhaust before starting the bike.
Congratulations! You have completed the installation of your new British Customs Passenger Peg Block-Offs.