- Triumph Bonneville
- Triumph Thruxton
- Triumph Scrambler
- T30 wrench
- Blue Loctite
Total time the job takes:
- 5 minutes
Note: Take care NOT to bend or scratch chain guard while unpacking.
Unscrew front bolt with a T30 Torx bit.
Unscrew rear T30 Torx bolt and lift stock chain guard up and back to remove
Tech Tip: The front screw is the longer of the two and has a washer.
Clean off old Loctite from bolt.
Recommended: Apply small amount of blue Loctite or equivalent medium thread locker to bolts.
Hold new chain guard in place and screw in rear bolt.
Screw in front bolt.
Ensure both bolts are torqued to 7 Nm and the chain guard is firmly fastened.
Congratulations! Your new British Customs Chain Guard has been successfully installed!