- Triumph Street Twin
- 4mm Allen wrench
- 10mm wrench
Total time the job takes:
- 5 minutes per side
Remove the stock bar end with a 4mm Allen wrench. Be advised that it's a tough screw to remove. To help, use a heat gun on the bar end weight, while taking care not to melt your grips. Use an 8mm wrench to remove the screw holding the stock mirror, if your bike came with bar end mirrors.
Use ample amounts of force to rock the mirror back and forth in order to remove it from the bar end.
If you need to use a bar end adapter, slide the screw through the new bar end adapter.
Put the bar end in place.
Thread the screw into the bar end.
Tighten the screw with a 4mm Allen.
Place the new bar end mirror over the adapter, adjust to desire position, and tighten clamp screw.
Your bar end mirror and adapter have been successfully installed!